seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Input shaft: > < Reverse gear shaft: Assembly overview

Leon Mk1

Reverse gear shaft: disassembly and assembly
   
Reverse gear shaft: disassembly and assembly
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t  Extractor kit -T20140-, see equivalent → Anchor
t  Extractor kit -U 40100B-, see equivalent → Anchor
t  Kit (case) -U 40200A-, see equivalent → Anchor
t  Kit (case) -U 40300-, see equivalent → Anchor

   
Remove the support axial/radial needle bearing of the clutch housing
–  Locate adapter -T20140/14- on axial/radial bearing.
–  Place adapter -T20140/1- on clutch casing and screw extractor shaft into adapter -T20140/14- until claws expand.
–  Work nut -1- until outer track of small roller bearing is extracted.
  Note
Release the claws and then expand again after the outer ring has been pulled out by approx.1 mm so that it sits completely on the base of the bearing.
  E35-0187
Install the support axial/radial needle bearing of the clutch housing
  E35-0044
Remove the support axial/radial needle bearing from the reverse gear shaft
  E35-10010
Fit the support axial/radial needle bearing for the reverse gear shaft
  E35-10011

Input shaft: > < Reverse gear shaft: Assembly overview