–
| Loosen the lock nuts on the adjustment bolts -1- and unscrew the adjustment bolts until the respective rocker rests on the push spring of the injector-pump unit. |
–
| With corresponding box spanner from spanner set -U-40020-, loosen the bolts -2- that hold the rocker shaft, beginning with the outer ones and working inwards, and remove the rocker shaft. |
–
| With corresponding box spanner from spanner set -U-40020-, loosen the bolt -3- holding the fixing block, and remove the block. |
–
| Lever out the injector-pump unit connector with a screwdriver. To avoid bending it, support the opposite side of the connector with your finger. |
–
| Check that each cylinder has its corresponding injector-pump unit. |
|
|
|