seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Conversion table by relevance > < Removing and installing parts of exhaust system

Leon Mk1

Glow plugs: verification
Glow plugs: verification
Special tools and workshop equipment required
   
t  Auxiliary cable kit -VAG 1594C-
t  Spanner -U-40082-
  W00-0477
t  Pressure tester -VAG 1527B-
Test prerequisites
l  Battery voltage at least 11.5 V
l  Ignition is turned off
Checking sequence
–  Unplug connectors from glow plugs.
  W00-2238
–  Connect the cable from the voltage tester -VAG 1527B- to the (+) positive battery terminal using the pincers from the auxiliary measurement set -VAG 1594C- .
–  Place the testing tip of the voltage tester -VAG 1527B- on to each glow plug, one after another.
–  Diode lights up: Glow plug okay
–  Diode does not light up: Replace glow plug
–  Fit the glow plugs using spanner -U-40082- to 15 Nm.
  N28-0185

Conversion table by relevance > < Removing and installing parts of exhaust system