Leon Mk1
|
1 - | Bolt. |
q | Fastening the engine bracket to engine |
q | Replace |
q | Specified torques and installation sequence → Fig.. |
2 - | Engine support |
q | removing and fitting → Chapter |
3 - | Bolt. |
q | Fastening the engine bracket to engine |
q | Replace |
q | Specified torques and installation sequence → Fig.. |
4 - | Engine assembly mounting to body |
q | Specified torques and installation sequence → Fig.. |
5 - | Engine cross member |
6 - | Engine carrier bolts to engine bracket |
q | Replace |
q | Specified torques and installation sequence → Fig.. |
7 - | Pendulum support |
8 - | Pendulum support bolt to subframe |
q | Specified torques and installation sequence → Fig.. |
9 - | Pendulum support bolts to gearbox |
q | Specified torques and installation sequence → Fig.. |
10 - | Assembly mounting bolts, gearbox to gearbox mounting |
q | Replace |
q | Specified torques and installation sequence → Fig.. |
11 - | Assembly mounting bolts, gearbox to body |
q | Replace |
q | Specified torques and installation sequence → Fig.. |
12 - | Gearbox assembly mounting |
13 - | Nuts for particulate filter bracket |
q | Replace |
q | 25 Nm |
|
stage: | Bolts 1) | Tightening torque / turning further angle |
1. | -1 … 3- | 7 Nm |
2. | -1 … 3- | 40 Nm |
3. | -1 … 3- | turn 180° further |
1) Renew. |
|
-A-1) | 20 Nm and then turn 90° further |
-B-1) | 30 Nm and then turn 90° further |
-Arrow- | Do not slacken |
1) Renew. |
Note
|
-A-1) | 30 Nm and then turn 90° further |
-B-1) | 40Nm + 90° turn |
-Arrow- | Do not slacken |
1) Renew. |
|
-A-1) | 40Nm + 90° turn |
-B-1) | 40Nm + 90° turn |
1) Renew. |