Leon Mk1
Balance shaft with bearing cap module - Assembly overview |
1 - | Cover |
q | Clean if dirty |
2 - | 5 Nm |
3 - | 14 Nm and then turn 180° further |
q | Tighten in several stages. |
q | Tighten diagonally from inside to outside. |
4 - | 14 Nm and then turn 180° further |
5 - | Balance shaft assembly with oil pump |
q | Before installing, check if the adjustment sleeve is centred relative to the cylinder block and if the O-ring is fitted on the bearing cap module. |
q | removing and fitting → Chapter |
6 - | O ring |
q | Replace |
q | Check for tight fit; is mounted on the bearing cap module |
q | Oil lightly when fitting |
7 - | cylinder block |
8 - | Dowel sleeve |
9 - | Chain tensioner with tensioning plate |
q | To remove lock with locking pin -T40011- |
q | removing and fitting → Chapter |
10 - | 8 Nm and then turn 90° further |
q | Replace |
11 - | Installation tool |
q | Locking pin -T40011- |
12 - | Chain for oil pump |
q | Observe installation position → Chapter, Removing and installing balancer shaft |
13 - | 23 Nm |
14 - | Sprocket / idle pulley |