Leon Mk1
Active carbon filter system - Components overview |
1 - | Breather line |
q | Towards the solenoid valve 1 for the active carbon filter (pulsed) -N80- in engine cavity |
q | Check that it is seated securely |
2 - | Vent pipe with pressure retention valve |
q | From the gravity valve → Item on the fuel tank |
q | Check that it is seated securely |
3 - | Breather connection |
q | Visible from below |
4 - | 10 Nm |
5 - | Throttle valve control mechanism -J338- |
q | 6-pin connector |
q | Gold plated contacts |
q | Heated by coolant |
q | If the throttle valve control mechanism is replaced, the new control part must be adapted to the engine control unit → Chapter; Functions and components: |
q | check → Chapter |
6 - | Solenoid valve 1 for active carbon filter (pulsed) -N80- |
q | In engine compartment, right |
q | Valve closed with ignition switched off |
q | Valve is activated (pulsed) by engine control unit when engine is warm |
7 - | Electric connector |
q | 2-pin, black |
8 - | Active carbon filter |
q | Installation location: in front right wheel housing |
q | To remove: |
Remove rear right-hand side wheel. |
Remove the rear right wheel housing protection |
Remove pipes → Item and → Item |
Remove bolt → Item and detach tank by bottom part |