Leon Mk1
Assembly overview - sump / oil pump |
1 - | Oil dipstick |
q | Oil level must not be above max. mark on dipstick! |
q | Marks → Fig. |
2 - | Camshaft housing |
3 - | Sealing cap |
q | Replace gasket if it shows signs of damage. |
4 - | Retaining valve |
5 - | Oil seal |
q | Replace if damaged |
6 - | Oil separator |
q | To remove, intake manifold must be removed → Chapter. |
q | Install with sealant D 176 501 A1 |
7 - | 9 Nm |
8 - | 0.3 … 0.6 bar oil pressure switch -F1-. |
q | Tightening torque: 20 Nm |
q | Checking oil pressure switch → Chapter. |
9 - | Electric connector |
10 - | Oil filter |
q | Observe installation instructions on oil filter. |
q | Remove and install with oil filter tool -3417-. |
q | Tightening torque: 20 Nm |
11 - | Oil pan |
q | Removing and installing → Chapter. |
q | Clean sealing surface before installing |
q | Install with silicone sealant D 176,501 A1 → Chapter |
12 - | 8 Nm and then turn 90° further |
q | Replace |
13 - | Suction pipe |
q | With integrated seal. |
14 - | 8 Nm |
15 - | Oil seal |
q | Replace if damaged |
q | Removing and installing → Chapter. |
16 - | 20 Nm |
17 - | Oil drain plug, 30 Nm |
q | With safety washer |
q | Replace |
18 - | Oil pump: |
q | Always replace completely |
q | Removing and installing → Chapter. |
19 - | 8 Nm and then turn 90° further |
q | Replace |
20 - | Seal |
q | Replace |