Leon Mk1
Silencer with fixtures |
1 - | Front exhaust pipe with catalyst |
2 - | Mark |
3 - | Double clamp |
q | Note the fitting position |
4 - | Measurement -a- = approx. 5 mm |
5 - | Squashed washer |
6 - | 40 Nm |
7 - | Presilencer1) |
8 - | Suspension element |
9 - | 25 Nm |
10 - | Suspension element |
q | Replace if worn |
11 - | Joining stay |
12 - | 15 Nm |
13 - | 20 Nm + 1/4 turn (90°) |
14 - | Rear silencer → Note |
15 - | Mark |
q | For double repair clamp → Item |
16 - | Double repair clamp |
q | Should be fit to the marks → Item |
17 - | Cutting place |
q | For cases of repair → Note |
q | Marked with three outstanding prints on the circumference of the exhaust pipe |
1) | In the standard version, the presilencer and the rear silencer form a single unit. For the effects of repair, the presilencer and the silencer are supplied separately, with a double clamp, → Item. Perpendicularly cut the joining pipe at cutting point → Item, using tool -U-40075- → Fig.. |