Leon Mk1
Exhaust manifold, front exhaust pipe with catalytic converter and attachments removing and installing |
1 - | Warm air collector plate |
2 - | 10 Nm |
q | Note tightening sequence → Fig. |
3 - | Exhaust manifold |
4 - | Gasket |
q | Renew |
5 - | 25 Nm |
q | Lubricate thread with “G5” |
6 - | Double clamp |
7 - | To front silencer |
8 - | 40 Nm |
9 - | Front exhaust pipe with catalytic converter |
10 - | Retaining ring |
q | Replace if damaged or worn |
11 - | Connector |
q | Black, 4-pin |
q | For Lambda probe -G39- and heater for Lambda probe -Z19- |
q | Contacts 3 and 4 gold-plated |
12 - | Lambda probe before catalytic converter -G39-* 50 Nm |
q | Grease thread only with “G5”. “G5” must not get into the slots on the probe body |
q | Remove and fit with-U-40080- |
q | In case of leaking, nip open and replace the o-ring |
13 - | 40 Nm |
q | Lubricate thread with “G5” |
q | Renew |
14 - | Support |
q | For electric wire |