Leon Mk1
Thermostat side |
1 - | Retainer |
2 - | Self-tapping bolt |
q | Maximum speed for the screwdriver: 350/min. |
3 - | From bottom of radiator |
q | → Item |
q | Coolant hose connection diagram → Chapter |
4 - | Connection |
5 - | O ring |
q | Renew |
6 - | Coolant thermostat |
q | Checking operation: heat-up thermostat in water the thermo element pin must move out. |
q | Temperature check: Opening starts (approx. 84 °C) and ends (approx. 98 °C) cannot be checked. |
7 - | To top of expansion tank |
q | Coolant hose connection diagram → Chapter |
8 - | To heat exchanger |
q | Coolant hose connection diagram → Chapter |
9 - | From expansion tank |
q | → Item |
q | Coolant hose connection diagram → Chapter |
10 - | Retaining clip |
q | Check seated securely |
11 - | From heat exchanger |
q | Coolant hose connection diagram → Chapter |
12 - | Coolant pump housing on cylinder block |
13 - | Seal |
q | Renew |
14 - | Coolant pipe |
15 - | Thermostat housing |
16 - | 10 Nm |
17 - | Coolant temperature sender -G62- |
q | For engine control unit |
q | With coolant temperature gauge sender -G62- |
q | If necessary release pressure in cooling system before removing |
18 - | Sealing plug |
q | If necessary release pressure in cooling system before removing |
19 - | To top of radiator |
q | → Item |
q | Coolant hose connection diagram → Chapter |