Leon Mk1
Part I |
1 - | Toothed belt guard - upper part |
2 - | Toothed belt |
q | Mark D.O.R. before removing |
q | Check for wear |
q | Do not kink |
q | Removing, installing and tensioning → Chapter |
3 - | 20 Nm + 1/4 turn (90 °) further |
q | Renew |
q | The turning further can be done in several stages |
q | The turning further angle can be measured with protractor -T20030- |
q | Hold with counter-hold -T20018A- to loosen and tighten the camshaft sprocket |
4 - | Camshaft sprocket |
q | Note position when installing the toothed belt → Chapter |
5 - | 10 Nm |
q | Install with D6 |
6 - | Rear toothed belt guard |
7 - | 12 Nm |
q | Renew |
8 - | Coolant pump |
q | With integrated seal |
q | Seal must not be separated from coolant pump |
q | Replace damaged or leaking coolant pump together with seal |
q | Check for ease of movement |
q | Dismount and assemble → Chapter |
9 - | 20 Nm |
10 - | Tensioner |
q | Checking → Chapter |
q | Removing, installing and tensioning → Chapter |
11 - | Crankshaft toothed belt sprocket |
q | Note position when installing the toothed belt → Chapter |
12 - | Belt pulley |
q | When installing note fixing arrangement |
q | Removing and installing ribbed belt → Chapter |
13 - | 20 Nm |
14 - | Ribbed belt |
q | Mark direction of rotation before removing |
q | Check for wear |
q | Do not kink |
q | Removing and installing → Chapter |
15 - | 90 Nm + 1/4 turn (90 °) further |
q | Renew |
q | Oil threads |
q | The turning further can be done in several stages |
q | The turning further angle can be measured with protractor -T20030- |
q | To untighten and tighten, attach the pinion with the pulley wrench -T20018A- |
16 - | Toothed belt guard - lower part |