Leon Mk1
Silencer with mountings |
1 - | Front exhaust pipe with catalytic converter |
2 - | M8: 25 Nm, M10: 40 Nm |
3 - | Mark |
q | Visible from below |
4 - | Dimension-a- ca. 5 mm |
5 - | Double clamp |
6 - | Mushroom head screw |
7 - | Front silencer → Note |
8 - | 25 Nm |
9 - | Connecting piece |
10 - | Circlip |
q | (según versiones) |
11 - | Mounting |
q | Renew if damaged |
12 - | Mounting |
q | Renew if damaged |
13 - | Rear silencer → Note |
14 - | Repair double clamp |
q | Must be slid onto the markings → Item |
q | Marked by impressions on connecting pipe |
15 - | Marking |
q | Visible from below |
q | For repair double clamp → Item |
16 - | Separating point |
q | For repair cases → Note |
1) | Front and rear silencers are installed as a single component as standard. In repair cases the front and rear silencers are supplied individually and a repair double clamp → Item is supplied as a joint. Cut through connecting pipe at right angles at separating point with a body saw e.g.-U-40075-. |