Leon Mk1
|
1 - | Plug |
q | Renew the gasket if deteriorated |
2 - | Oil pressure switch at 0.5 bar, 25 Nm |
q | Green |
q | Check → Chapter |
3 - | 10 Nm |
4 - | Guide tube |
5 - | Filling funnel |
q | Remove in case of oil drainage by absorption |
6 - | Dipstick |
q | The oil level should not exceed the maximum mark! |
q | Marks → Fig. |
7 - | Camshaft pinion |
q | Check the position when installing the toothed belt → Chapter |
8 - | Oil filter |
q | Loosen with the nut or with -U-40078- |
q | Hand-tighten |
q | Follow the assembly instructions printed on the filter |
9 - | Gasket |
q | Renew |
q | It should be fitted on the adjustment hoses |
10 - | Tensioning roller |
q | Tighten the toothed belt → Chapter |
11 - | 20 Nm |
12 - | Toothed belt |
q | Before removal, mark the direction of rotation |
q | Check the wear |
q | Do not fold |
q | Removing and installing, tighten → Chapter |
13 - | Toothed belt upper guard |
14 - | Toothed belt lower guard |
15 - | 20 Nm |
16 - | 90 Nm + 1/4 turn (90°) |
q | Renew |
q | Fit lubricated |
q | The retightening can be carried out in several stages. |
q | The retightening angle can be measured with -T20030-. |
17 - | Pulley |
q | Check the mount during installation |
18 - | Toothed belt-crankshaft pinion |
q | Check the position when installing the toothed belt → Chapter |
19 - | 8 Nm |
20 - | Oil seal |
q | Renew → Chapter |
21 - | Duocentric oil pump |
q | Always renew the unit |
q | When installing, bear in mind the crankshaft drive element → Item |
q | It should be fitted on the adjustment hoses |
q | Removing and installing → Chapter |
22 - | Gasket |
23 - | Suction pipe |
q | Clean the strainer if dirty. |
24 - | Element for towing |
q | Apply a layer of lubricant before oil pump installation. |
25 - | Oil seal |
q | Renew |
26 - | Oil bleed screw |
q | Metal sump: 30 Nm |
q | Aluminium sump: 20 Nm |
27 - | Oil sump |
q | Remove and install for engines with liquid seals → Chapter. |
q | Before assembly, clean the watertight surface. |
q | Install with silicon-based sealant -D 176 404 A2-. |
28 - | 15 Nm |
q | Aluminium engine block: renew the bolts (covered with sealant) |
29 - | O-ring |
q | Renew |
30 - | Oil separator |
31 - | Toward air filter |