Leon Mk1
| Components of the ignition system: disassembly and assembly |
| 1 - | Earth strap |
| 2 - | Connector |
| 3 - | 10 Nm |
| 4 - | Ignition transformer -N152- |
| q | With final step -N157- |
| 5 - | Anti-static connector |
| q | 0.6 … 1.4 kΩ |
| 6 - | Protective cover |
| 7 - | Distributor cover |
| q | Make sure that there are no cracks or marks of electrical discharge |
| q | Check the wear of the contacts |
| q | Clean it before placing it |
| q | Check the wear of the brush and that it moves smoothly |
| 8 - | Ignition distributor rotor |
| q | Identification: R1 |
| q | 0.6 … 1.4 kΩ |
| 9 - | Dust protector |
| 10 - | Cylinder 1 mark |
| 11 - | Hall transmitter ignition distributor -G40- |
| q | Disassembly and assembly → Chapter |
| q | Check and adjust the ignition timing → Diagnostics operations unitVAS 5051 |
| 12 - | O-ring |
| q | Renew if deteriorated |
| 13 - | 20 Nm |
| q | The tightening torque influences the functioning of the pinking sensor. |
| 14 - | Pinking sensor 1 -G61- |
| q | Golden contacts on the sensor and connector |
| 15 - | Plug, 25 Nm |
| q | Type and removal of electrodes → Chapter |
| 16 - | Spark plug lid |
| q | 4 … 6 kΩ |
| q | Use tool -T10029-, to remove the spark plug lid with ignition cable |
| 17 - | Ignition cable |
| q | Check the flow continuity |
