seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Renewing crankshaft sealing flange - flywheel end > < Removing and installing cylinder block, sealing flange and flywheel

Leon Mk1

Pressing sealing flange with sender wheel off crankshaft
Pressing sealing flange with sender wheel off crankshaft
  Note!
To show the work sequence more clearly, the sequence is described for a removed engine.
Work sequence
–  Remove pressure plate.
–  Remove flywheel. Hold flywheel with counter-hold -T20075A- when doing this.
–  Remove intermediate plate.
–  Set engine to TDC No. 1 cylinder → Chapter.
–  Remove oil sump → Chapter.
   
–  Remove engine speed sender -arrow-.
–  Undo sealing flange securing bolts.
  N13-0380
–  Screw Qty. 3 M6×35 mm bolts into the threaded holes -arrows- of the sealing flange.
–  Screw the bolts alternately (a 1/2 turn (180°) for each bolt) into the sealing flange and press the sealing flange along with the sender wheel off the crankshaft.
  N13-0381

Renewing crankshaft sealing flange - flywheel end > < Removing and installing cylinder block, sealing flange and flywheel