Leon Mk1
Exhaust manifold, front exhaust pipe and catalytic converter with attachments |
1 - | Warm air collector plate |
q | Orden de apriete → Fig. |
2 - | 10 Nm |
3 - | Exhaust manifold |
q | With built-in precatalyser, only in ANV or AUC engines |
4 - | Gasket |
q | Renew |
5 - | Lock nut, 25 Nm |
6 - | Lambda probe 2 after catalytic converter -G130-, 50 Nm |
q | Only in ANV or AUC engines |
q | Grease only the threads with “G 052 112 A3”; “G 052 112 A3” must not get into the slots on the probe body |
q | Remove and install with ring spanner -U-40080- |
7 - | To silencer |
8 - | Marking |
q | Visible from below → Item |
9 - | Connector |
q | Only ANV or AUC engines |
q | For Lambda probe 2 after catalytic converter -G130- and Lambda probe heating -Z29- |
q | Black, 4-pin |
10 - | Front exhaust pipe with catalytic converter |
q | Replace → Chapter |
11 - | 25 Nm |
12 - | Tunnel bridge |
q | With retainers for front exhaust pipe with catalytic converter |
q | Renew if damaged |
13 - | Lock nut, 40 Nm |
14 - | Connector |
q | For Lambda probe 1 before catalytic converter -G39- and Lambda probe heating -Z19- |
Identification letters for ALD engine |
q | Black, 4 contacts |
Identification letters for ANV, AUC engine: |
q | Black, 6 contacts |
15 - | Lambda probe 1 before catalytic converter -G39-, 50 Nm |
q | Grease only the threads with “G 052 112 A3”; “G 052 112 A3” must not get into the slots on the probe body |
q | Remove and install with ring spanner -U-40080- |
16 - | Bracket |
q | For electrical wiring of Lambda probe 1 before catalytic converter |
Note!
|