t
| Engine and gearbox support beam -U-30025B- |
t
| Hydraulic jack for column - SAT 1001A- |
–
| Remove the front exhaust pipe from its attachment to the connector. |
–
| Put the Engine and gearbox support beam -U-30025B- into place and remove the attachment bolts from the rear supports for the drive unit (disconnect the connection from the lambda probe 2). |
–
| Remove the tunnel bridge and the double clamp that attaches the catalyser to the central pre-silencer. |
–
| Lower the group holder beam partially with the aid of the Hydraulic jack for column -SAT 1001A- (if necessary, remove the attachment bolt from the hinge shaft for the steering). |
–
| Remove the heatproof plate and extract the front exhaust pipe stretch with the catalyser. |
Perform the assembly in the reverse order to that established for the dismounting. |
|
|
|