seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gas recirculation system > < Front exhaust pipe with catalyser: Replace

Leon Mk1

Silencer with mountings
   
Silencer with mountings
1 - Front exhaust pipe with catalytic converter
2 - M8: 25 Nm M10: 40 Nm
3 - Mark
q   Visible from below
4 - Dimension-a- = ca. 5 mm
5 - Double clamp
6 - Mushroom head screw
7 - Front silencer → Note
8 - 25 Nm
9 - Connecting piece
10 - Circlip
q   Renew if damaged
q   (según versiones)
11 - Mounting
12 - Mounting
q   Renew if damaged
13 - Rear silencer → Note
14 - Repair double clamp
q   Must be slid onto the markings → Item
q   Marked by impressions on connecting pipe
15 - Marking
q   Visible from below
q   For repair double clamp → Item
16 - Separating point
q   For repair cases → Note

1)  Front and rear silencers are installed as a single component as standard. In repair cases the front and rear silencers are supplied individually and a repair double clamp → Item is supplied as a joint. Cut through connecting pipe at right angles at separating point -16- with a body saw e.g. -U-40075-.
   

Exhaust gas recirculation system > < Front exhaust pipe with catalyser: Replace