All other vehicles continued |
–
| Unscrew the lambda probe -G39--3- using the tool from the tool set e/c 17 -3337-. |
Installation is carried out in reverse order, noting the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body. |
t
| With used lambda probes, heat the bolt before coating with paste. The paste must not get into the slots on the probe body. For high-temperature paste refer to → Parts catalogue. |
t
| When installing, the Lambda probe wiring must always be re-attached at the same locations (under all circumstances) to prevent it from coming into contact with the exhaust pipe. |
–
| See lambda probe for tightening torque: Assembly overview → Chapter |
–
| See lambda probe for tightening torque: Assembly overview → Chapter |
|
|
|