Leon Mk1
Assembly overview - sealing flanges and flywheel |
1 - | Seal |
q | Do not additionally oil or grease the oil seal sealing lip. |
q | Note differing versions of seal. |
q | PTFE seal with no inner coil spring |
q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
q | Renewing crankshaft oil seal - pulley end → Chapter. |
2 - | Sealing flange |
q | Must seat on dowel sleeves. |
q | Removing and installing → Chapter. |
q | Install with silicone sealant -D 176 404 A2- |
3 - | Cylinder block |
q | Removing and installing crankshaft → Chapter |
q | Dismantling and assembling pistons and conrods → Chapter |
4 - | Flywheel/drive plate |
q | Removing and installing flywheel, vehicles ► 05.00: lock with counterhold tool -3067-. |
q | Removing and installing flywheel, vehicles 06.00 ►: lock with counterhold tool -3415-. |
q | Removing and installing drive plate → Chapter |
5 - | 60 Nm + 1/4 turn (90°) further |
q | Renew. |
6 - | Intermediate plate |
q | Must seat on dowel sleeves. |
q | Do not damage or bend when assembling. |
7 - | 15 Nm |
8 - | Sealing flange with oil seal |
q | Renew complete only. |
q | Do not additionally oil or grease the oil seal sealing lip. |
q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
q | Use support sleeve supplied when installing |
q | Do not remove support sleeve until sealing flange has been slid onto crankshaft journal |