seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Pistons and conrods > < Removing and installing sealing flange - pulley end

Leon Mk1

Removing and installing drive plate
Removing and installing drive plate
Special tools and workshop equipment required
   
t  Clutch counterhold tool -VW 558-
t  Hexagon bolt M8×45 and two M10 hexagon nuts
t  Depth gauge
Loosening and tightening drive plate
  W00-0252
–  Secure clutch counterhold tool -VW 558- to drive plate with hexagon bolt M8x45. Insert two M10 hexagon nuts between counterhold tool and drive plate.
Installation position of counterhold tool: A - To loosen, B - To tighten.
–  Loosen drive plate bolts.
Installing drive plate
  V13-0993
–  Fit drive plate using packing plate with recesses -1-.
–  Fit new bolts -3- and tighten to 30 Nm.
  N13-0640
–  Check dimension -a- at three points and calculate average. Specification: 19.5… 21.1 mm
  Note
Measure through hole in drive plate to milled surface of cylinder block.
If specification is not attained:
  N13-0641
–  Remove drive plate again and fit shim -2-. Tighten bolts -3- again to 30 Nm.
–  Tighten bolts -3- to 60 Nm and turn 90° (1/4 turn) further (the additional 1/4 turn can be done in several stages).
  N13-0640

Pistons and conrods > < Removing and installing sealing flange - pulley end