Leon Mk1
|
– | Remove noise insulation. |
– | Place drip tray -V.A.G 1306- underneath. |
– | Remove air filter housing. |
– | Remove union nut -2- or banjo bolt -4- from oil filter bracket. |
– | Remove bolt -6-. |
– | Remove union nut -2- from exhaust turbocharger. |
– | Remove bolt -9- from bracket -7-. |
– | Remove nut -8- and take off bracket -7-. |
– | Remove oil supply line -1-. |
|
Installation is carried out in the reverse sequence of removal. In the process, note the following: |
WARNING
|
– | Screw bracket -7- with nut -8- loosely to exhaust manifold. |
– | Screw union nut -2- or banjo bolt -4- to oil filter bracket hand-tight. |
– | Screw union nut -2- to exhaust turbocharger hand-tight. |
– | Tighten union nut -2- or banjo bolt -4- on oil filter bracket to torque setting. |
– | Tighten union nut -2- on exhaust turbocharger to tightening torque. |
– | Position clamps -5- on oil supply line. |
– | Tighten bolts -6- and -9- to tightening torque. |
– | Tighten nut -8- to prescribed torque. |