–
| Remove circlip -1- using circlip pliers. |
–
| Screw a M3 bolt -2- in and pull drive shaft out of oil pump -arrow-. |
–
| Unscrew bolt -4- and pull suction pipe off oil pump. |
–
| Remove bolts -13- and -35- and remove oil pump. |
Caution Bolt on intermediate gear wheel must not be loosened. |
|
Installation is carried out in the reverse order; note the following: |
Note t
| Renew damaged or over-tensioned circlip. |
t
| Circlip must lie in base of groove. |
–
| Ensure both dowel sleeves are in place before installing oil pump. |
|
|
|