Leon Mk1
Assembly overview - toothed belt drive |
1 - | Toothed belt guard upper part |
2 - | Toothed belt |
q | Mark direction of rotation before removing. |
q | Check for wear. |
q | Do not kink. |
q | Removing, installing and tensioning → Chapter. |
3 - | 20 Nm + 1/8 turn (45°) further |
4 - | Tensioning roller |
5 - | 100 Nm |
6 - | 25 Nm |
7 - | Camshaft pulley |
8 - | Hub |
q | With sender wheel. |
q | Use counter-hold tool -T10051- to loosen and tighten. |
q | To remove, use puller -T10052-. |
q | Removing and installing → Chapter. |
9 - | 10 Nm |
10 - | Rear toothed belt guard |
11 - | Sealing grommet |
q | Renew if damaged. |
12 - | Idler roller |
13 - | Coolant pump |
q | Installed in cylinder block |
q | Check for ease of movement. |
q | Note installation position. |
q | Removing and installing → Chapter. |
14 - | Crankshaft toothed belt pulley |
15 - | 120 Nm + 1/4 turn (90°) further |
q | Renew |
q | Use counter-hold tool -3415- to loosen and tighten. |
q | Do not additionally oil or grease the threads and shoulder |
q | Turning further can be done in several stages. |
16 - | 15 Nm |
17 - | 20 Nm |
18 - | Toothed belt guard lower part |
19 - | Belt pulley and vibration damper |
q | Can only be installed in one position. Holes are offset. |
20 - | 10 Nm + 1/4 turn (90°) further |
21 - | Cover |
22 - | Toothed belt guard centre part |
23 - | 30 Nm |
24 - | 45 Nm |
25 - | Engine support |
26 - | 45 Nm |