seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and positioning the engine > < Safety precautions

Leon Mk1

Removing and installing torque reaction support of the engine
Removing and installing torque reaction support of the engine
t  Removing → Anchor
t  Installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor
  W00-0427
Removing
–  Loosen quick-type locks -1 and 2-, and remove front noise insulation.
  A10-1320
–  Unscrew bolts -3- from engine torque support -1-.
–  Remove the torque reaction support of the engine -1-.
Installing
Installation is carried out in reverse order. The following should be taken into account:
  A34-10504
–  Move torque reaction support of the engine -1- upwards until it makes contact with the cross member -Direction of arrow-.
  Note
Bump stop -2- must be in contact with cross member without play, but must not be under tension.
–  Then tighten bolts -3- to specified tightening torque → Item.
  A34-10504

Removing and positioning the engine > < Safety precautions