Leon Mk1
Valve system: Assembly overview |
1 - | Seal |
q | Do not grease or oil the seal lip of the seal |
q | Before fitting, use a clean cloth to wipe off oil residue on camshaft journal. |
q | To install, tape over (e.g. using Sellotape) groove in taper of camshaft |
q | Removing and installing → Chapter |
2 - | 10 Nm |
q | Loosen following the indicated sequence → Fig. |
q | Note correct sequence when tightening → Fig. |
3 - | 10 Nm |
4 - | Bearing cap module |
q | With integrated camshaft bearings |
q | Loosen following the indicated sequence → Fig. |
q | Note correct sequence when tightening → Fig. |
q | Clean sealing surface; machining not permitted. |
5 - | Exhaust camshaft |
q | Removing and installing → Chapter |
6 - | Supply camshaft |
q | Removing and installing → Chapter |
7 - | Roller rocker arms |
q | Removing and installing → Chapter |
q | Mark the installation position |
q | Do not exchange position |
q | Check roller bearing for ease of movement. |
q | Oil contact surface. |
8 - | Hydraulic valve compensation element |
q | With retaining clip |
q | Mark the installation position |
q | Lubricate contact surfaces before installing. |
9 - | Valve |
q | Not to be reworked, only grinding in is permissible |
q | Mark installation position for re-installation |
q | Valve dimensions → Chapter |
q | Checking valve guides → Chapter |
10 - | Cylinder head |
q | See note → Chapter |
11 - | Valve stem seal |
q | Removing and installing → Chapter |
12 - | Valve spring |
13 - | Valve plate spring |
14 - | Woodruff keys |
15 - | Sealing plug |
q | Replace |
|