Leon Mk1
Toothed belt drive: Assembly overview |
1 - | Notched belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not bend |
q | Removing and installing → Chapter |
2 - | 20 Nm |
3 - | Guide roller |
4 - | 50 Nm + 90° (1/4 turn) |
5 - | Nut, 20 Nm + 45° (1/8 turn) |
6 - | Tensioning roller |
q | To avoid significant damage to the engine apply correct tightening torques |
7 - | 25 Nm |
8 - | Camshaft sprocket |
9 - | Guide roller |
10 - | 15 Nm |
11 - | 100 Nm |
12 - | Hub |
q | Use counterhold -T10051- to loosen and tighten |
q | To remove, use puller -T10052-. |
q | Removing and installing → Chapter |
13 - | 5 Nm |
14 - | Toothed belt cover (rear) |
15 - | 20 Nm |
16 - | 5 Nm |
17 - | Guide roller |
18 - | Hub |
q | With sender wheel |
q | Use counterhold -T10051- to loosen and tighten |
q | To remove, use puller -T40064-. |
q | Removing and installing → Chapter |
19 - | 100 Nm |
20 - | High-pressure pump sprocket |
21 - | Upper protection element for the notched belt |
22 - | 20 Nm + 90° (1/4 turn) |
23 - | Coolant pump |
q | Removing and installing → Chapter |
24 - | 15 Nm |
25 - | Crankshaft sprocket |
26 - | 120 Nm + 90° (1/4 turn) |
q | Replace |
q | Use counterhold -3099- to loosen and tighten |
q | Do not additionally oil or grease the threads and shoulder. |
q | Turning further can be done in several stages. |
27 - | Notched belt guard - lower part |
28 - | Notched belt guard - centre part |
29 - | 10 Nm |
30 - | Belt pulley and vibration damper |
q | Can only be installed in one position, holes are offset. |
31 - | 10 Nm + 90° (1/4 turn) |
q | Replace |