Leon Mk1
Oil filter bracket with oil cooler: Assembly overview |
1 - | Seal |
q | Replace |
2 - | 15 Nm + 1/4 turn (90º) |
q | Replace |
q | First fit upper left and lower right bolts and then tighten all 4 bolts in diagonal sequence. |
3 - | Oil filter bracket |
q | Removing and installing → Chapter |
q | Ensure clearance from surrounding components |
4 - | Seal |
q | Replace |
5 - | Connection sleeve 30 Nm |
6 - | Oil supply canal, 22 Nm |
q | To turbocharger |
7 - | Oil pressure switch -F1-, 22 Nm |
q | Identification: Brown colour |
q | 0.7 bar. |
q | In case of leakage, cut out and replace sealing ring |
q | Checking → Chapter |
8 - | Sealing plug, 25 Nm |
9 - | O ring |
q | Replace |
10 - | Oil filter element |
q | See note. |
q | Observe change intervals. |
11 - | Seal |
q | Replace |
q | Installation position → Fig. |
q | Lubricate before installing |
q | Engage in projections on oil cooler |
12 - | Oil cooler |
q | Ensure clearance from surrounding components |
q | See note. |
13 - | Seal |
q | Replace |
14 - | Screw cap, 25 Nm |
15 - | 10 Nm |
16 - | Spring retainer |
q | For the cable harness |
|