SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Crankshaft >
< Dismantling and assembling pistons and conrods
Leon Mk1
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Enginecrankshaft group, pistons
Dismantling and assembling engine
Removing and installing vibration damper
Removing and installing vibration damper
t
Removing
→ Anchor
.
t
Installing
→ Anchor
.
t
Specified torques
→ Anchor
.
Removing
.
–
Remove poly V-belt
→ Chapter
.
–
Fit the centre noise insulation
-fasteners 1 ... 3-
.
–
Remove the right wheel housing
-Fixing parts 1 ... 3-
.
–
Remove the vibration damper hood.
–
Unscrew the vibration damper. For this purpose, counterhold using a ring spanner.
Note
To loosen and to tighten the vibration damper, hold it on the centre bolt using a ring spanner.
Installing
.
Installation is carried out in the reverse order of removing, when doing this note the following.
–
Use new bolts.
–
When installing the vibration damper, use only genuine bolts (same as original equipment):
→ Parts catalogue
.
l
Fitting can only be completed in one position only: The hole
-arrow-
in the vibration damper must fit over the projection on the pulley.
Specified torques
.
Component
Nm
Vibration damper to the crankshaft notched pulley
10 + 90°
→ Remark
→ Remark
1)
Replace bolts
2)
90º is equivalent to a quarter turn
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Enginecrankshaft group, pistons
Dismantling and assembling engine
Crankshaft >
< Dismantling and assembling pistons and conrods