SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Engine control unit with antitheft protection: removing and fitting >
< Adapting functions and components
Leon Mk1
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Fuel preparation system Diesel injection
Engine control unit
Engine control unit with antitheft protection: Removing and installing.
Engine control unit with antitheft protection: Removing and installing.
Engine control unit with antitheft protection: Removing and installing.
→ Chapter „Engine control unit with antitheft protection: removing and fitting“
.
t
Removing
→ Anchor
.
t
Installing
→ Anchor
.
Note
To replace the engine control unit, connect the central diagnosis -VAS 5051B- or central diagnosis -VAS 5052- and complete the guided function „Replace control unit“.
Removing
.
–
Switch off ignition.
–
Remove the front plate of the plenum chamber
→ Bodywork exterior fitting work; Rep. gr.50
.
–
Release front connector
-1-
from engine control unit and pull it off.
–
Lever up catch
-2-
slightly.
–
Then push engine control unit out of retainer
-arrow-
.
–
Then release rear connector on engine control unit and pull it off.
Installing
.
–
Fit rear connector to engine control unit and lock in position.
–
Push engine control unit onto bracket.
–
Fit front connector to engine control unit and lock it in position.
–
Fit the front panel on the plenum chamber
→ Bodywork - exterior installation work; Rep. gr.50
.
–
Interrogate and erase fault memory if necessary
→ Chapter
.
Power unit
4-cylinder engine (2.0l 4V, TDI Common Rail)
Fuel preparation system Diesel injection
Engine control unit
Engine control unit with antitheft protection: Removing and installing.
Engine control unit with antitheft protection: removing and fitting >
< Adapting functions and components