Leon Mk1
Lambda probe: Assembly overview |
1 - | Particle filter |
q | Removing and installing the particulate filter in vehicles with manual gearbox → Chapter |
q | Removing and installing the particulate filter in vehicles with automatic gearbox → Chapter |
q | Perform new adaptation after replacing particle filter. See "Guided troubleshooting" → Vehicle diagnostic tester" (work also described under "Guided functions"). |
2 - | Exhaust gas temperature sender 1 -G235-, 45 Nm |
q | Removing and installing → Chapter |
q | Apply hot bolt paste to the thread → Spare parts catalogue. |
3 - | Turbocharger |
q | Removing and installing → Chapter |
q | With charge pressure actuator position sender -G581- |
4 - | Lambda probe -G39- with heater for lambda probe -Z19-, 50 Nm |
q | removing and fitting → Chapter |
q | New Lambda probes are coated with an assembly paste |
q | With used lambda probes, heat the bolt before coating only the thread with paste → Spare parts list. |
q | The assembly paste / high-temperature paste must not get into the slots on the Lambda probe body |
5 - | Pressure differential sender -G505-, 4.5 Nm |
q | removing and fitting → Chapter |
q | Use the pressure line on the particle filter to remove and install the tool kit e/c 17 -T10395- |
q | Pressure pipes to particulate filter: 45 Nm |
6 - | Exhaust gas temperature sender 3 -G495-, 45 Nm |
q | Removing and installing → Chapter |
q | Apply hot bolt paste to the thread → Spare parts catalogue. |
7 - | Primary exhaust pipe |
q | Removing and installing → Chapter |
q | With exhaust temperature sensor 4 -G648- |
8 - | Exhaust gas temperature sender 4 -G648-, 45 Nm |
q | removing and fitting → Chapter |
q | Apply hot bolt paste to the thread → Spare parts catalogue. |
|