–
| Disconnect electrical connection -1- for lambda probe -G39-. |
–
| Screw out the Lambda probe -G39--5- using the wrench -3337/1-. |
When installing, note the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body. |
t
| In the case of a used Lambda probe grease only the thread with high-temperature paste. The paste must not get into the slots on the Lambda probe body. For high-temperature paste refer to → Parts catalogue. |
t
| When installing, the Lambda probe wiring must always be re-attached at the same locations to prevent it from coming into contact with the exhaust pipe. |
t
| Tightening torque of the Lambda probe: 50 Nm |
|
|
|