Leon Mk1
Fuel tank with accessory parts: Assembly overview |
Note
The ill. shows a fuel system without return line. |
1 - | Fuel line |
q | From fuel filter. |
q | To engine. |
q | Do not bend |
q | To disengage, press the clip in the joint to unlock it |
2 - | Breather line |
q | For the active carbon filter system in front right wheel housing |
q | Do not bend |
q | To disengage, press the clip in the joint to unlock it |
q | Install on fuel tank |
3 - | 2 Nm |
4 - | Heat shield |
q | For fuel filler neck |
5 - | 23 Nm |
q | Secures fuel filler neck and earth connection → Item |
6 - | Overflow hose |
q | Engage in wheel housing |
7 - | Rubber bearing |
8 - | Tensioning ring |
9 - | Seal |
q | If this is damaged, replace it |
10 - | Sealing plug |
q | Fitted on tank flap unit with a securing device |
11 - | Earth connection |
q | To divert electrostatic charge |
q | Installation position / Testing standard → Fig. |
q | Ensure correct fitting of the connector and securely tighten the line with the securing bolt for the fuel filler neck → Item |
q | After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body: Approx. 0 Ω |
12 - | Breather line |
13 - | Fuel tank |
q | removing and fitting → Chapter |
14 - | Heat shield |
q | For fuel tank. |
15 - | 2 Nm |
16 - | Heat shield |
q | For fuel tank. |
17 - | 2 Nm |
18 - | Spreader clip |
19 - | tension belt |
q | Note different lengths |
20 - | 23 Nm |