Leon Mk1
Ignition system - Assembly overview |
1 - | Connector |
q | Black, 4 contacts |
q | Loosen with the assembly tool -T10118- |
2 - | Ignition coil 3 with output stage -N291- |
q | Ignition coil 1 with output stage -N70- |
q | Ignition coil 2 with output stage -N127- |
q | Ignition coil 4 with output stage -N292- |
q | Removing and fitting → Chapter |
3 - | Connector |
q | Black, 2-pin |
q | For the knock sensor 1 -G61- |
q | Connector contacts are gold-plated |
4 - | Knock sensor 1 -G61- |
q | Connector contacts are gold-plated |
5 - | 20 Nm |
q | The torque setting influences the function of the knock sensor. |
6 - | Connector |
q | Black, 3 contacts |
q | for Hall sender -G40- |
7 - | Hall sender -G40- |
8 - | O-ring |
q | Replace this if it is damaged |
9 - | 10 Nm |
10 - | Spark plug, 30 Nm |
q | Remove and fit with the spark plug spanner -3122 B- |
q | Type and spark gap → Chapter |
11 - | Cable guide |
q | Tighten the camshaft housing to a torque of 5 Nm |
12 - | Earth cable |
q | Tighten or loosen only when the ignition is off |
13 - | 10 Nm |
q | Tighten or loosen only when the ignition is off |