Leon Mk1
Part II Engine block - Assembly overview |
1 - | cylinder block |
q | Dismantling and assembling the aluminium cylinder block → Chapter |
q | Dismantle and assemble pistons and conrods → Chapter |
2 - | 50 Nm |
q | Tightening order: First tighten the upper right-hand bolt, then the lower right-hand one and finally the left-hand bolts ( viewed in direction of travel) |
3 - | M8: 20 Nm + 1/4 (90°) turn, M10: 45 Nm |
4 - | Oil filter |
q | Loosen at hexagonal |
q | Tighten by hand |
q | Observe the installation instructions printed on the filter |
5 - | 13 Nm |
q | Loosen and fasten the bolts on the side of the flywheel using the socket -T10058-. |
6 - | Oil sump |
q | Clean sealing surface before installing |
q | Fit using sealant -D 176 404 A2- |
q | Removing and fitting → Chapter |
7 - | Oil drain plug, 30 Nm |
q | With safety washer |
q | Replace. |
8 - | Bracket |
q | For tension device, alternator and air conditioner's compressor |
9 - | Tensioning element |
q | Poly-V belt |
q | Poly-V belt: removing and installing → Chapter. |