Leon Mk1
1 - | Warm air collector plate |
2 - | 10 Nm |
3 - | Lambda probe -G39-, 55 Nm |
q | Apply high-temperature lubricant -G 052 112 A3- to thread only. The high-temperature lubricant -G 052 112 A3- must not get into the slots on the probe body. |
4 - | Exhaust manifold with precatalyst |
q | Protect from damage by knocks and impact |
5 - | Seal |
q | Replace. |
6 - | 25 Nm |
q | Replace. |
7 - | Suspension |
8 - | 25 Nm |
9 - | Front sleeve, tightening torque, 25 Nm |
q | Align exhaust system when it is cold so it is free of stress before tightening clamp |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
10 - | Goes to pre-silencer |
11 - | Front tube bridge |
12 - | Gearbox |
q | Protect from damage by knocks and impact |
13 - | 23 Nm |
14 - | Lambda after catalytic converter -G130- 55 Nm |
q | Apply high-temperature lubricant -G 052 112 A3- to thread only. The high-temperature lubricant -G 052 112 A3- must not get into the slots on the probe body. |
q | The connector is located under the right hand side vehicle floor housing. |
15 - | Connector |
q | 4 pins |
q | For Lambda probes after the catalytic converter -G130- |
16 - | 25 Nm |
17 - | 20 Nm |
18 - | 40 Nm |
q | Replace. |
19 - | Bracket |
20 - | Exhaust pipe |
q | With flexible connection (de-coupling element) |
q | Do not bend flexible connection more than 10º - Risk of damage |
21 - | Cableguide |
|