–
| Disconnect the hose -1- from the retention valve. |
–
| Pull the air filter housing up, removing it from the support pins -2-. |
Installation is performed in the reverse sequence. The following must be taken into account: |
Note t
| To attach the upper body of the air filter housing onto the lower one as the suction inlet, use a set of self tapping screws. If these screws are loosened or tightened with a screwdriver, the thread of the upper element of the air filter may be damaged. |
t
| For this reason a power tool can only be used when: |
t
| The power tool maximum speed is 200 rpm, |
t
| Tightening torque is set to a maximum of 3 Nm. |
|
|
|