Leon Mk1
Assembly overview - part I, belt drive |
1 - | 40 Nm + 1/4 turn (90°) further |
q | To loosen and tighten securing bolt, counterhold supercharger shaft with 16 mm spanner. |
q | replace |
2 - | Pulley |
q | For supercharger. |
3 - | 23 Nm |
4 - | Tensioning element |
q | For supercharger poly V-belt |
q | Relieve tension using 16 mm spanner. |
q | Lock with locking pin -T10060 A-. |
5 - | 8 Nm |
6 - | Coolant pump with magnetic clutch for supercharger -N421- |
q | removing and installing → Chapter |
q | Removing and installing coolant pump pulley → Chapter. |
7 - | 23 Nm |
8 - | Tensioning element |
q | For Poly-V belt |
q | Relieve tension using 16 mm open-end spanner -T10241-. |
q | Lock with locking pin -T10060 A-. |
Note
t | Vehicles with a manual gearbox: idler roller installed instead of tensioning element. |
t | Specified torque for securing bolt: 40 Nm. |
9 - | 23 Nm |
10 - | Alternator |
11 - | Pulley |
q | For crankshaft |
q | With diamond coated washer |
q | Contact surfaces must be free of oil and grease. |
12 - | Securing bolt |
q | Removing and installing crankshaft pulley → Chapter. |
q | replace |
q | Contact surface for securing bolt must be free of oil and grease. |
q | Oil threads before inserting. |
q | Secure belt pulley against turning with counterhold -3415-. |
q | Turning further can be done in several stages. |
q | The turning further angle can be measured with a commercial protractor. |
13 - | 40 Nm + 1/4 turn (90°) further |
q | Removing and installing when the vehicle is lifted |
q | replace |
14 - | Air conditioning compressor |
15 - | 23 Nm |
16 - | Tensioning element |
q | For Poly-V belt |
q | Relieve tension with spanner. |
q | Lock with 4 mm Allen key. |
17 - | Poly-V belt |
q | Mark direction of rotation before removing. |
Caution
|
q | Removing and installing poly V-belt → Chapter. |
18 - | Poly-V belt |
q | For supercharger. |
q | Mark direction of rotation before removing. |
Caution
|