seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Engine data

Leon Mk1

Securing engine to assembly stand
Securing engine to assembly stand
When working on engine, secure it with engine and gearbox support -VW 540- and engine and gearbox support supplement -VW 540/1 B- to support clamp -VW 313- of the assembly stand.
Procedure
–  Remove gearbox.
Vehicles with automatic gearbox
–  Secure torque converter against “falling out” after separating engine from gearbox.
Continuation for all vehicles
–  Bolt engine and gearbox support -VW 540- and supplementary set for engine and gearbox support -VW 540/1 B- to cylinder block.
   
–  Attach lifting tackle -2024 A- as follows and lift engine from engine and gearbox support -VW 540- using workshop crane -V.A.G 1206A- or workshop crane -VAS 6100-.
Pulley end: 1st hole in hook rail at position 4
Flywheel end: 3rd hole in hook rail at position 8.
  Caution
The hooks and locating pins must be secured with locking pins.
  Note!
t  The positions marked 1...4 on the bar must be towards the pulley end.
t  The holes in the hooks are counted up from the hook.
–  Fit engine in support clamp -VW 313- using workshop crane -V.A.G 1206A- or workshop crane -VAS 6100-.
  N10-0164

Enginecrankshaft group, pistons > < Engine data