Leon Mk1
Dismantling and assembling oil filter bracket: engine code AWC |
Note!
t | Hose connections are secured with either spring-type or clamp-type clips. |
t | Always replace clamp-type clips with spring-type clips. |
1 - | O-ring |
q | Push on to shoulder of pipe. |
q | Renew if damaged. |
2 - | Connecting pipe |
3 - | T-piece |
q | With non-return valve. |
4 - | Connecting hose |
q | To connection on lower intake manifold. |
5 - | Pipe |
q | For crankcase breather |
6 - | Securing clip |
q | Check for secure seating. |
7 - | Plug, 15 Nm |
q | If sealing ring is leaking, nip open and renew. |
8 - | Oil supply line |
q | To turbocharger → Item. |
9 - | Banjo bolt, 30 Nm |
10 - | Seal |
q | Renew. |
11 - | 1.4 bar oil pressure switch -F1-, 25 Nm |
q | Identification: black |
q | Checking → Chapter. |
q | If sealing ring is leaking, nip open and renew. |
12 - | 15 Nm + 1/4 turn (90 °) further |
q | Renew. |
q | Turning further can be done in several stages. |
13 - | Seal |
q | Renew. |
q | Lubricate before installing. |
q | Fit into lugs on oil cooler. |
14 - | Oil cooler |
q | Ensure clearance to adjacent components. |
q | Coat contact surface to oil filter bracket outside the seal with sealing paste -AMV 188 100 02- |
q | See note → Chapter. |
q | Coolant hose connection schematic diagram: engine code AWC → Chapter. |
15 - | 25 Nm |
16 - | Oil filter |
q | Observe change intervals |
q | Loosen with strap wrench. |
q | Tighten by hand. |
q | Observe installation instructions on oil filter. |
q | See note → Chapter. |
17 - | Oil filter bracket |
q | With pressure relief valve, approx. 4 bar |
q | Ensure clearance to adjacent components. |
18 - | Plug, 40 Nm |
q | If sealing ring is leaking, nip open and renew. |
19 - | Spring |
q | For pressure relief valve, approx. 4 bar. |
20 - | Piston |
q | For pressure relief valve, approx. 4 bar. |
21 - | Gasket |
q | Renew. |
22 - | Non-return valve |
q | Insert into oil filter bracket (no longer bolted to oil filter bracket). |