Leon Mk1
| Part II |
| 1 - | Knock sensor 1 -G61- |
| q | Checking (engine code AJH) → Rep. Gr.01. |
| q | Checking (engine code AWC) → Rep. Gr.01. |
| 2 - | 20 Nm |
| q | The torque setting influences the function of knock sensor 1 -G61-. |
| 3 - | Knock sensor 2 -G66- |
| q | Checking (engine code AJH) → Rep. Gr.01. |
| q | Checking (engine code AWC) → Rep. Gr.01. |
| 4 - | Oil dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings → Fig. |
| 5 - | Dipstick guide |
| q | For oil dipstick. |
| q | Secured with bracket to intake manifold. |
| 6 - | O-ring |
| q | Renew. |
| 7 - | Coolant pipe |
| q | Coolant hose connection schematic diagram: engine code AJH → Chapter. |
| q | Coolant hose connection schematic diagram: engine code AWC → Chapter. |
| 8 - | 20 Nm |
| 9 - | Gasket |
| q | Renew. |
| 10 - | Oil filter bracket |
| q | Ensure clearance to adjacent components. |
| q | Dismantling and assembling: engine code AJH → Chapter. |
| q | Dismantling and assembling: engine code AWC → Chapter. |
| 11 - | 15 Nm + 1/4 turn (90°) further |
| q | Renew. |
| q | Turning further can be done in several stages. |
| 12 - | 10 Nm |
| 13 - | Engine speed sender -G28- |
| q | Checking (engine code AJH) → Rep. Gr.01. |
| q | Checking (engine code AWC) → Rep. Gr.01. |
| 14 - | Connection |
| 15 - | 15 Nm |
| 16 - | Thermostat |
| q | Removing and installing → Chapter. |
| q | Observe installation position, → Chapter, Removing and installing thermostat. |
| q | Checking: heat thermostat in water. |
| q | Opening begins at approx. 87 °C. |
| q | Ends at approx. 102 °C. |
| q | Opening lift min. 7 mm. |
| 17 - | 25 Nm |
| 18 - | Support |
| q | Between intake manifold and cylinder block. |
| 19 - | 45 Nm |
| 20 - | Compact bracket |
| q | For alternator, air conditioner compressor and P.A.S. vane pump. |
| 21 - | Bracket |
| q | Only for vehicles with engine code AJH. |
| q | For turbocharger/charge air cooler air pipe. |
| 22 - | 40 Nm |
| 23 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrod → Chapter. |
| 24 - | Spacer sleeve |
| q | Only vehicles with manual gearbox. |
| 25 - | 25 Nm |
| 26 - | Support |
| q | Between turbocharger and cylinder block. |
