Leon Mk1
Part III |
1 - | Cylinder block |
q | Block, crankshaft oil seal and engine flywheel/traction disk → Chapter |
q | Crankshaft → Chapter |
q | Piston and piston rod → Chapter |
2 - | O-ring |
q | Replace if damaged |
3 - | 20 Nm + 1/4 turn (90°) |
q | Replacement |
4 - | Vacuum pump |
5 - | Attachment part |
6 - | 20 Nm |
7 - | Connection union |
q | Cylinder block breather |
8 - | Gasket |
q | Replacement |
9 - | Seal bolt, 25 Nm |
q | For other engine identification letters |
10 - | To the turbocompressor to the exhaust gases |
q | For other engine identification letters |
11 - | O-ring |
q | Replacement |
12 - | 25 Nm |
13 - | Oil filter bracket |
14 - | Oil cooler |
q | Grease using -AMV 188 100 02- the contact surface of the oil filter support, outside of the O-ring |
q | Ensure clearance to adjacent components |
q | Observe the note → Chapter |
15 - | Oil filter |
q | Tighten by hand |
q | Follow the fitting instructions printed on the filter |
q | Replace → Chapter |
16 - | 10 Nm |
17 - | Engine transmission |
18 - | 30 Nm |
19 - | Support |
q | For Poly-V belt without tensioning pulley |
20 - | Hammer type bolt |
21 - | Tensioning element |
22 - | O-ring |
q | Replace if damaged |
23 - | Support |
q | For Poly-V belt with tensioning pulley |
24 - | Tensioning rod |
q | Lubricate using -G 000 100- |
25 - | Coolant pump |
q | Removing and fitting → Chapter |
26 - | Sump |
q | Clean sealing surface before installing |
27 - | 20 Nm |
q | Extract the rear bolts towards the gearbox using the -U-40051A- tool |
28 - | Support |
q | For vane pump |
29 - | Gasket |
q | Fitted to the anti-vibration plate |
q | Replace if damaged |
30 - | Pin |
q | Check if it is seated properly |