seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel supply system > < Cooling system: disassembly and assembly

Leon Mk1

Accelerator control: disassembly and assembly
   
Accelerator control: disassembly and assembly
1 - Securing clip
2 - Accelerator control cable
q   Adjust by changing the position of the securing clip on the regulator element → Fig.
3 - Securing clip
4 - Counterweight
5 - Fastener
6 - Push the accelerator pedal fully down
7 - Accelerator pedal
q   Removing and fitting → Fig.
8 - Pivot pin
9 - 10 Nm

   
Adjust the accelerator control
–  With the accelerator pedal fully down, adjust the accelerator control cable by changing the position of the securing clip on the attachment element -arrow- in such a way that the injection pump lever is all the way and not under any tension.
  V23-0090
Removing and fitting the accelerator cable
–  To remove the accelerator pedal, remove gently the fastener for the pedal axle -arrows-. Then rotate the axle with a 6 mm Allen key until it is released.
–  To fit the accelerator pedal, the pedal is put in place and the axle inserted. Ensure that the fastener is in position and then connect the accelerator cable.
  N20-0042

Fuel supply system > < Cooling system: disassembly and assembly