seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cooling > < Valve stem seals: replace

Leon Mk1

Dismantling
Dismantling
   
–  Remove lower engine protection. → General body repairs-assembly work; Rep. Gr.50
–  Drain engine oil.
  Note!
Observe disposal regulations!
–  Remove sump.
–  Loosen the sump by gently tapping it with a rubber hammer.
–  Remove sealant residue on cylinder block with a flat scraper.
  E10-0098
–  Remove sealant residue on the sump with a rotating brush, e.g. a hand drill with a plastic brush (wear protective goggles).
–  Clean sealing surface, must be free of oil and grease.
  N17-0012

Engine cooling > < Valve stem seals: replace