Leon Mk1
Exhaust system: dismantling and assembling |
1 - | Gasket |
q | Renew |
2 - | Exhaust manifold |
q | With connection for exhaust gas recirculation → Chapter |
q | To remove, the intake manifold has to be removed |
3 - | Washer |
4 - | 25 Nm |
q | Renew |
q | Grease thread with -G 052 112 A3- |
5 - | Front exhaust pipe with catalyst |
6 - | Retaining ring |
q | Renew if damaged |
7 - | Cross member |
8 - | 23 Nm |
9 - | Double clamp |
q | Note assembly position: Bolts downwards and in a horizontal position → Fig. |
10 - | 40 Nm |
11 - | Suspension element |
q | Note assembly position → Fig. |
12 - | Suspension element |
q | Note assembly position → Fig. |
13 - | Separating point |
q | For repair cases |
q | Marked by three impressions on circumference of exhaust pipe |
q | As standard, front and main silencers come as a single component. In cases of repair the rear silencer and exhaust are supplied individually and with a double clamp for connecting. |
q | Cut the exhaust pipe perpendicularly at the indicated point with tool -U-40075- → Fig.. |
14 - | To front silencer |
q | Can be replaced individually → Fig. |
q | Note installation position → Fig. |
15 - | 40 Nm |
q | Renew |
q | Apply insulation paste to the thread -G 052 112 A3- |
|