Front exhaust pipe with catalyst: replacing |
–
| Remove the front exhaust pipe from its fastening to the manifold. |
–
| Fit crossmember -U-30025- and remove the mounting bolts from the rear engine unit supports (disconnect the connection of lambda probe 2). |
–
| Remove the tunnel bridge and the double clamp that holds the catalyst to the middle presilencer. |
–
| Lower the engine unit support partially with hydraulic jack -SAT 1001- (if necessary, remove the mounting bolt from the articulated steering shaft). |
–
| Remove the antithermal plate and remove the front exhaust pipe section with catalyst. |
Install in the reverse order of removal. |
|
|
|