Leon Mk1
Part I |
1 - | Upper toothed belt shield |
2 - | Toothed belt |
q | Before removing, mark the direction of rotation |
q | Check for wear |
q | Do not fold |
q | Removing and fitting, tightening → Chapter |
3 - | 20 Nm + 1/4 turn (90o) |
q | To loosen and tighten, immobilise the camshaft pinion with countersupport -T20018A- |
q | Retightening may be done in several steps |
q | The retightening angle may be measured with protractor -T20030- |
q | Replace |
4 - | Camshaft pinion |
q | Bear in mind the fitting position when fitting the toothed belt → Chapter |
5 - | 10 Nm |
q | Fit with D6 |
6 - | Rear toothed belt shield |
7 - | 12 Nm |
q | Replace |
8 - | Coolant pump |
q | With gasket incorporated |
q | Do not remove the gasket from the coolant pump |
q | In the event of breakage or leakage, replace the coolant pump with gasket |
q | Check that it turns easily |
q | Removing and fitting → Chapter |
9 - | 20 Nm |
10 - | Tensioning roller |
q | Testing → Chapter |
q | Tighten the toothed belt → Chapter |
11 - | Toothed belt-crankshaft pinion |
q | Check the fitting position and fit the toothed belt → Chapter |
12 - | Pulley |
q | Check the position when fitting |
q | Remove and fit the Poly-V belt → Chapter |
13 - | 20 Nm |
14 - | Poly-V belt |
q | Before removing, mark the direction of rotation |
q | Check for wear |
q | Do not fold |
q | Removing and fitting → Chapter |
15 - | 90 Nm + 1/4 turn (90o) |
q | Replace |
q | Oil before fitting |
q | To loosen and tighten, immobilise the pinion with countersupport -T20018A- |
q | Retightening may be done in several steps |
q | The retightening angle may be measured with protractor -T20030- |
16 - | Lower toothed belt shield |