–
| Disconnect connector -4-. |
WARNING Hot steam/hot coolant can escape - risk of scalding. |
The cooling system is under pressure when the engine is hot. |
Cover filler cap on expansion tank with a cloth and open carefully to dissipate pressure. |
|
–
| Unscrew the bolt -2- and remove the pump for the exhaust gas recirculation radiator -V400- with the bracket. |
–
| Clamp off coolant hoses using hose clamps -3094-, release hose clips -1- and disconnect coolant hoses. |
–
| Remove bolts -3- and detach pump for exhaust gas recirculation cooler from bracket. |
Installation is carried out in reverse order. Note the following: |
Note t
| Hose connections and air pipes and hoses must be free from oil and grease before fitting. |
t
| Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue. |
t
| To ensure that the air hoses can be connected securely, you must spray the screw threads on used screw-type clips with rust remover prior to installation. |
–
| Install air hoses with screw-type clips → Fig.. |
|
|
|