Leon Mk1
Fuel supply unit and fuel level indicator sender: Assembly overview |
1 - | Fuel delivery unit |
q | Checking fuel pump (electrical test) → Chapter |
q | Removing and installing → Chapter. |
q | Put at least 5 litres of fuel into tank after installing |
2 - | Fuel gauge senders -G- |
q | Checking resistance values → Chapter |
q | Removing and installing → Chapter. |
3 - | Depending on version |
4 - | Seal |
q | Replace |
q | Install dry |
5 - | Fuel return line |
q | From fuel filter. |
q | Mark before removing |
q | To disengage, press the clip in the joint to unlock it |
q | Do not kink |
q | Note the direction of the arrow (fuel supply or fuel return system) on flange when installing |
q | Install on fuel tank |
6 - | Fuel supply line |
q | To fuel filter |
q | Mark before removing |
q | To disengage, press the clip in the joint to unlock it |
q | Do not kink |
q | Note the direction of the arrow (fuel supply or fuel return system) on flange when installing |
q | Install on fuel tank |
7 - | Electric connector |
q | For fuel pump -G6- |
8 - | Electric connector |
q | For the fuel gauge sender -G- |
9 - | Locking ring, 110 Nm |
q | Check for secure seating. |
q | Removing and installing with the rotation tool -T10202- |
10 - | Electric connector |
q | For fuel pump control unit -J538- |
11 - | Fuel pump control unit -J538- |
q | Installation location: On the cover of the fuel delivery unit. |
12 - | Spray jet: |