–
| Insert counterhold tool -10 - 201- in hole on cylinder block -item B-, slacken bolts for drive plate. |
Caution Take care not to damage outer surface of bearing flange on drive plate. |
Use a multi-point socket bit with a length of at least 40 mm to slacken and tighten the drive plate bolts. |
|
–
| Remove the screws. Detach the drive plate. |
Reassembly is carried out in the reverse order; note the following: |
Note t
| Renew the bolts tightened with specified tightening angle. |
t
| On vehicles with manual gearbox, a needle bearing is fitted in the drive plate. Before installing, check that the needle bearing is fitted. Removing and installing needle bearing in drive plate (pressing in and out) → Chapter. |
–
| Pay attention to dowel pin when installing drive plate. |
–
| Insert counterhold tool -10 - 201- in hole on cylinder block -item A-, tighten the drive plate screws. |
|
|
|